ProxmarkPro - Cloning a HID Tag

April 02, 2019

This blog post covers the steps to clone a HID tag to a T5577 with a ProxmarkPro.

For this blog post you will need the following:

1. Turn on your ProxmarkPro and connect the Low Frequency Antenna.

2. Enter Unchained Mode and navigate to the HID menu.

HID Menu

3. With the HID tag in the Antennas field select the Read option. If read successfully the display should say HID tag found and the UID. Click the right button to continue back to the HID menu. Your tag will be saved to the internal memory (chip) at this point.

Reading a HID tag

4. Navigate to the Clone option in the HID menu. Place the T5577 tag in field and press the Clone option. If successful the ProxmarkPro should now show Complete.

Cloning a HID Tag

5. Double check the HID tag was cloned successfully by trying to read it. If it reads with the correct UID then you have successfully cloned your HID Tag.

Note: Once you turn off your ProxmarkPro your current tag will be removed from the internal memory. To avoid losing the tag data you can always save the HID tag to your SD card and clone it later at any point. Just click the Save option in the HID menu. 






Also in Blog

Proxmark Pro - Sniffing a Mifare Desfire 4K Tag
Proxmark Pro - Sniffing a Mifare Desfire 4K Tag

October 21, 2019

This post covers how to Sniff a Mifare Desfire 4K tag with the ProxmarkPro.

View full article →

ProxmarkPro - Sniffing a Mifare 4K Tag
ProxmarkPro - Sniffing a Mifare 4K Tag

October 21, 2019

This post covers how to Sniff a Mifare 4K tag with the ProxmarkPro.

View full article →

ProxmarkPro - Sniffing a Mifare 1K Tag
ProxmarkPro - Sniffing a Mifare 1K Tag

October 21, 2019

This post covers how to sniff a Mifare 1K tag with the ProxmarkPro.

View full article →

We use cookies to ensure that we give you the best experience on our website. If you continue we'll assume that you are understand this. Learn more
Accept